Ok, here is what I have:
(2) Dell PowerEdge 1950's
(2) Cisco 3750G's using StackWise for a redundant pair
(1) QLE4062C iSCSI HBA in each Dell server
EqualLogic PS5000E SAN
Ok, I have successfully configured the HBA port 1 for boot from SAN and have ESX installed. I'm not sure the correct way to setup the 2nd port for failover. Should I configure it with the same settings as port 1 in the Qlogic BIOS? Even the same IP address? Or should I configure this through ESX once I'm in. I'm assuming I should setup the second port for boot from SAN, but I'm not 100% sure and a bit new to this stuff. Thanks for any help.
Dan