I'm trying to enable multipathing to a Dell MD3000i iSCSI target using the software initiator.
The target has 2 controllers with 2 NIC's each.
I have added every ip address on each target NIC to the "Dynamic Discovery/Send Targets" pane.
The storage view only show one path.
I have rescanned and rebooted the host severak times without any luck.
This is my config:
ESX host:
1 vSwitch with VM traffic bound to vmnic0 & vmnic1
1vSwitch with Console and VMkernel bound to vmnic2 and vmnic3
Console IP: 192.168.130.11
VMkernel IP: 192.168.130.21
DELL MD3000i iSCSI SAN:
Controller0
NIC0: 192.168.130.101
NIC1: 192.168.130.201
Controller1
NIC0: 192.168.130.102
NIC1: 192.168.130.202
Is multipathing supported using the Software initiator?
If it's supported, what am I doing wrong?
(I am aware of that the MD3000i is not official suppprted by VMware.)
Regards
Bernt Torbjørnsen