Hi
I'm trialing a installation of ESX3.5 on a HP Proliant ML150 G3 (Yes i realise that this is not on the supported hardware list) This box has two 160Gb SATA drives with a raid controller. RAID was in a RAID1 format before the install.
Ideally i would like the ESX to be installed on RAID1/RAID0
I am a newbie at installing ESX i have not done it before. I've gone through the install once and when i came to creating the install partitions the options i had was two 140GB drives. Does this mean that the RAID controller has not been seen by the ESX install? Or are there other steps i need to go through.
Many Thanks
Kane
If you found my post helpful, please mark it as 'helpful' or 'correct'