Hi all, I'm an ESX newbie so please forgive any dumb questions/terms....
I had an esx 3.0.1 host blue screen on me last week after a sudden power outage and I couldn't recover it. So I upgraded it to 3.0.2 which went well, rebooted, checked all the vlans and config was still there, all fine, except....
now there are no LUNS showing in Storage.
A pair of hba's are still available in Storage adaptors (QLA2432's) - both come back on rescan so I believe they're up and functioning.
However, each of them shows in the details screen show "Targets: 0"
The hba's connect through a fibre switch into a san and that's all working correctly as the other ESX hosts can still see the storage.
I've tried re-adding storage by lun name/wildcard match etc but nothing is seen, presumably as the hba's are not seeing the SAN at all.
I don't believe it's a driver issue as I've checked another 3.0.2 host with the same hba's and they're both using same drivers.
Only other clue I have is that all 3 lights on back of hba's are blinking (1,2,4) - 1 is blinking red, 2 and 4 are blinking green.
No other obvious errors at boot of the esx host.
Any suggestions as to where to start?
Many thanks
Andy